Wire Connections

Forum Forums SI 2015 General Wire Connections

This topic contains 3 replies, has 3 voices, and was last updated by  Seth Enos 2 years ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
  • #6782 Reply

    Ryan Jones

    is their any way to label wire connections for per-terminated patch cords without doing a visio drawing?

    #9020 Reply

    Christian Brøndbo

    When you add the wires to the project they get a component ID that can be reported on. You can’t add connections manually as that is dynamic data based on what terminals the wire is connected to at the time of reporting.

    #9021 Reply

    Ryan Jones

    i see that the wires get a component id but if i run a report the from device and the two device are blank how do i fill this in? i am trying to list where all my connections will go before the project starts

    #9023 Reply

    Seth Enos

    The stock wire reports require that connections be made in Visio or AutoCAD with our shapes/blocks. You could use Custom Fields to manually fill in the connections for each wire and then create a custom report that displays those Custom Fields if you aren’t going to be doing drawings.

Viewing 4 posts - 1 through 4 (of 4 total)
Reply To: Wire Connections
Your information:

<a href="" title="" rel="" target=""> <blockquote cite=""> <code> <pre> <em> <strong> <del datetime=""> <ul> <ol start=""> <li> <img src="" border="" alt="" height="" width="">