Shapes don’t always snap to rack edge

Forum Forums Visio Tools / Interface Shapes don’t always snap to rack edge

This topic contains 1 reply, has 2 voices, and was last updated by  Christian Brøndbo 6 years ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #5839

    Jay Carney
    Participant

    I’ve been building a MA rack with product shapes d/l from the manufacturer.

    I’ve zoomed to 200%, but I’m having issues with them snapping to the rack. The “Rack Mount” is checked and I find the product that has built in ears don’t have this issue, but AVRs, etc. that have rack ears as accessaries have the problem.

    The problem also exists with spacing between product. Sometimes it won’t snug up to the other product in the rack..

    Thanks for your thoughts!

    #6998

    Christian Brøndbo
    Participant

    I’ve had the same problem myself. It might be caused by variations in the size data (1U is 44.45mm, 2U is 88,9mm). Check that the rack width and height is within the standards. I have often used a few extra guidelines as a quick workaround.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.