Price Rules – Round-Up and Minimum Price

Forum Forums D-Tools General Forum Data Price Rules – Round-Up and Minimum Price

This topic contains 2 replies, has 2 voices, and was last updated by  Naresh 2 years ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #6279 Reply

    Blanton
    Participant

    Is there a way to create a Price Rule to “Round-up” to next whole dollar or to set a “Minimum Price” rule?

    Thanks

    #8101 Reply

    Blanton
    Participant

    Similar to this “Round-Up” is the 4 place decimals. This 4 digit capability is great for cable. Helps tremendously with Accounting. Is there a way to turn it off? Cable is a big issue, yes, but it starts to creep into products and gives errors on materials totals, say CAT6 Patch cables. We may purchase them at $1.62 with 30% Margin and sell at 2.3143. 200 is OK at $462.86. If we use 175 however, $375.025 is the same issue as cable spools, the other way. Is there a rule or selection to always round up to 2 places? I’d much rather sell these patch cables at 30.17% margin or set the price to $2.32 each, automatically. A choice on decimal places? I do not know why I would, but I cannot set my Phase Cost/Hr. Labor to 14.4557. It is rounded to 2 places.

    Thanks.

    #8976 Reply

    Naresh
    Moderator

    Hi,

    Sounds good.

    We will consider adding Rounding options to Price Rules for our next release SI 2016.

    Regards,

    Naresh

Viewing 3 posts - 1 through 3 (of 3 total)
Reply To: Price Rules – Round-Up and Minimum Price
Your information:





<a href="" title="" rel="" target=""> <blockquote cite=""> <code> <pre> <em> <strong> <del datetime=""> <ul> <ol start=""> <li> <img src="" border="" alt="" height="" width="">