AutoCAD PLINE and DTEQPT

Forum Forums D-Tools General Forum Bugs AutoCAD PLINE and DTEQPT

This topic contains 3 replies, has 1 voice, and was last updated by  jimmy Wright 9 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #12899

    jimmy Wright
    Participant

    The d-tools created schematic blocks do not allow for attachment of PLINES unless they are d-tools objects. PLINE attachment points on these blocks are not available for attachment of any other line types.

    DTEQPT blocks also do not allow for snapping points.

    The D-tools/Autocad integratioin for schematics is atrocious, its time for an actual update/revamp of this integration, as it has been relatively unchanged for 3+ years.

    #12900

    jimmy Wright
    Participant

    Or, can you guys just go ahead and integrate with autocad electrical….?

    #12913

    jimmy Wright
    Participant

    bump

    #12952

    jimmy Wright
    Participant

    ?

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.