2010 Vs. 2013

Forum Forums Visio Compatibility 2010 Vs. 2013

This topic contains 2 replies, has 3 voices, and was last updated by  Peter Mejer 6 years ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #6397


    I’m currently Using D-tools version 6.2.850.0

    I am wanting to upgrade from 2007 Visio but not sure if I should go all the way to 2013 as you can see the comment below from the Dtools Hardware/software requirements… any one have some input on that? Is it only 2010 that can fully take advantage of the shapes?


    * To fully take advantage of the SIX Visio Shapes you need to use Visio 2010.



    Adam Stone


    Currently Visio 2010 is the best option. Visio 2013 works fine with D-Tools SIX but it has a documented issue with importing AutoCAD files. Microsoft has said that they are aware of the issue it will be resolved in SP1 due in March. More info at the link below.



    Peter Mejer

    There is A LOT of issues with 2013. Do not go further than 2010 if possible.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.